Cleanup of the 1/2 cut...

Well... Finally gotten around to work on the 1/2 cut... First task of the rank was to start with cleaning it up (No, not with soap and water kind!!!!) and removing some of the unnecessary panels, dash, radiator, etc.



First things I did, was to remove the easy and most important components... these were...
- Backtop M/T ECU
- Map Sensor
- Ignitor & Coil

These were stored in a safe place...

Sean, my best buddy, was very keen to assist me with this project, and I certainly could do with a hand. Alas, up to this point, Sean was very busy with work... but he was getting a bit more free time, so ... Cool... :-) I have to admit... Sean, being my best buddy, I confiding a lot of my personal stuff to him. He suggested that I should proceed with this 20v Blacktop engine... as I had a difficult time between choosing turbo charging and 20v BT engine route.

More to follow in next post...